Taglierina al plasma, Pilot Arc BTC500DP 7th Generation 50Amps Screen Display Dual Voltage 110/220V Macchina da taglio al plasma digitale (BTC500DP 7Gen 110/220V)

الجهاز ممتاز ماشاء الله والبايع جدا متعاون ويرد عليك بسرعه من اول ما ترسل له انصح به

Works fantastic, and had $100 off coupn. Quality materials, $400.00 cheaper than my local store..

This is a great non-touch plasma torch. The design makes it easy to set up all cutting parameters. It’s lightweight, with all external connections done without tools. It’s equipped with an air dryer, which should extend the torch expendable parts life. All controls are on the front panel, easily set and read, except for on/off switch. It can be flipped on or off from the front, once you know it’s located.I’ve cut metal with for years but I’m a first time plasma user. I quickly cut various thickness and conditions of steel, and found it intuitive how to set up the pressure and current. There’s a chart with recommendations, but I found thinner metal below 3/8” could be cut cleanly and quickly with the same setting. All you need to do is cut at the best rate, and that’s learned quickly within the first inch of cutting.I did find it more difficult to punch a hole through thicker metal with plasma than Oxy-acetylene (3/8” and thicker), but the thinner metal was as easy as Oxy-acetylene. I’m sure when I developed the proper technique, the thicker gauge metal will punch easily.I felt so confident after 15 minutes of playing with my new torch, I started and finished two projects I’d been waiting to do because my acetylene bottle was empty.With plasma; all you need is an air compressor, and electricity. And this unit will work on 110 or 220, and both have a 50% duty cycle. For my two projects I was cutting with 220, and it cut both 7/16 and 16 gauge quickly and cleanly by only changing air pressure and current. With Oxy-acetylene I would have had to change tips and played with torch settings and pressures as well. Plasma is so much easier, with no expense of gas, and bulk of the torch and hoses. I’ll never go back!If anyone that reads this wants to buy an Oxy-acetylene system lock-stock-and barrel call me;-).

They sure did choose the right name for this Plasma cutter ( BESTARC ) it really does stand out from the rest, I have been cutting with plasma for a while and was ready for a new machine and this is the one. I have not used better.Highly recommend.

This plasma cutter is a true pilot arc machine, easy to set up, for Australian users, cut the American style power plug off and fit a 3 pin 15amp plug. first test on the thickness of steel that I use the most, cut through it like butter, clean cut, the Lincoln 210 struggled to cut 8mm plate, the BTC5000DP had no trouble.Am very happy with this plasma cutter, a shout out to Petes Tools, after viewing his channel, I bought my own Bestarc plasma cutter